Electrical wiring & installation in Khafji: cost & published offers

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Before we start: what we know about Khafji

Main roads in or near Khafji: King Abdullah Road. Team note on Khafji: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins..

Khafji is about 2 km from the sea coast (OpenStreetMap). The centre of Khafji sits about 9 m above sea level (SRTM open elevation data).

Electrical wiring and installation work in Khafji starts with the location itself. The centre of Khafji sits about 9 m above sea level (SRTM open elevation data), and the town is about 2 km from the sea coast (OpenStreetMap). For a technician, these facts mean the first checks cover how the building is laid out relative to the coast and its exposure to salt air, which can affect the condition of outdoor junction boxes, earthing points, and metal fittings. Before any quote is firmed up, the technician looks at the existing supply, the condition of the distribution board, and where new circuits will run.

The site visit is where the real scope is set, and it is also where a cost figure is first confirmed. A site visit and quantity survey typically falls in the range of SAR 150–400 per visit. During the visit, the technician counts outlets, lighting points, and planned appliances, notes wall and ceiling finishes that will need chasing or making good, and checks whether split air conditioning units will need dedicated circuits. Anything that depends on the actual building, such as cable routes, the state of old wiring, and access to ceiling voids, can only be judged on site, so the final price for wiring work is not set until this survey is complete.

For the technician, a few points are worth noting in advance. If split AC supply and installation is part of the job, the published range is SAR 350–900 per unit, and each unit usually needs its own supply route. If the work sits inside a wider fit-out, related trades are priced separately: gypsum board false ceiling at SAR 40–90 per m², plastering with guides at SAR 15–35 per m², and painting with surface preparation at SAR 8–25 per m². Tiling with adhesive and grout is SAR 25–60 per m². Where wiring is coordinated with these trades, it helps to sequence chasing and cable installation before plastering and ceiling boards go in, so the finished surfaces are not damaged.

Prices shown on this page come from our own published price list for the city; the final price is set after inspection.

Signs worth paying attention to

These are the signs most often linked to electrical wiring & installation:

• Old wiring in a renovation
• Too few sockets
• Breakers that trip often

The most common causes

• Poor connections — we check this before anything else.
• A common cause: overloaded circuits.
• A common cause: old cables.

Tools we use in Khafji

From the first visit to the report

1. Load survey: Rooms, appliances and loads are listed.
2. Plan: Circuits and points are marked.
3. Installation: Conduits, cables and boxes are installed.
4. Testing: Every circuit is tested before handover.

Facts and costs — Khafji

Short answers for Khafji

What we advise against

• Adding points without checking the circuit load

The written outputs

You receive: a circuit plan and the test results, in a technical report with a verification code.