AC installation & ducting in Tabuk: for companies (annual contract)

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Before we start: what we know about Tabuk

Team note on Tabuk: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. The centre of Tabuk sits about 762 m above sea level (SRTM open elevation data).

Tabuk sits at the centre of the region at about 762 m above sea level, which gives the city a high-plateau climate with hot summers, cooler nights and dust that moves across open ground. For a company this matters because cooling load is driven by both heat and the air that enters a building. Installers in Tabuk therefore plan unit capacity and outdoor placement with the summer peak in mind, and they check that condenser units have clear airflow and protection from blowing sand.

Practical planning starts with the cost structure. Split AC supply and installation ranges from SAR 335 to SAR 855 per unit, so the number and size of indoor units drive most of the budget. Where ducting runs through an annex or rest-house building, costs are estimated per square metre, between SAR 665 and SAR 1,710 per m². Companies that add a site visit and quantity survey, priced at SAR 145 to SAR 380 per visit, get accurate routes for ducts and drains before any cutting begins. A gypsum board false ceiling, at SAR 40 to SAR 85 per m², is often the cleanest way to hide ducting, and plastering with guides, at SAR 15 to SAR 35 per m², and painting with surface preparation, at SAR 10 to SAR 25 per m², finish the work neatly afterwards.

Owners who run offices, clinics and warehouses in Tabuk avoid several common mistakes. They do not size units from the floor area alone, and they do not skip the survey, because missing routes lead to rework. They do not leave ducts exposed to dust without sealing joints and filters. They do not treat decor works, priced from SAR 30 to SAR 95 per m², as an afterthought, since ceilings and finishes must be planned with the ducting. Finally, they do not compare quotes that cover different scopes. Where a single contractor handles everything, general contracting on a turnkey basis is priced from SAR 855 to SAR 2,375 per m², and full finishing to handover from SAR 285 to SAR 760 per m² keeps responsibility clear.

For companies, an annual contract sets the scope, the visit schedule and the reports in writing.

Signs that call for AC installation & ducting

The following signs are worth checking before they grow:

• Units that drip or cool weakly
• A new space that needs cooling
• Replacing old units

Where the problem usually comes from

• A unit size that does not suit the room — we check this before anything else.
• Long or poorly insulated copper runs.
• A common cause: no proper drain line.

How we choose the tool in Tabuk

The steps in order

1. Survey: Room sizes and unit positions are checked.
2. Sizing: Unit capacity is chosen for each room.
3. Installation: Units, copper, drain and breaker are installed.
4. Testing: Pressure, cooling and drainage are checked.

Quick comparison: facts and costs in Tabuk

Short answers for Tabuk

Common mistakes we see

• Choosing a unit by price, not by room size

The written outputs

The written output: the unit capacities, the routes and the test results. The report is numbered and can be checked with its verification code.