Hidden water leak detection in Al Shfa, Jeddah: cost & published offers

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Al Shfa for hidden water leak detection

The centre of Al Shfa is at 21.3823, 39.3352, about 24.6 km from the centre of Jeddah, with an approximate radius of 1.2 km. The service-area circle on the map below is drawn from this point. Al Shfa is about 15.3 km from the sea coast (OpenStreetMap).

The centre of Al Shfa sits about 117 m above sea level (SRTM open elevation data). The nearest wadi channel is about 3 km from the centre of Al Shfa (OpenStreetMap).

Is there a hidden leak in my Al Shfa property, and what will it cost to find out? Most owners here ask this after noticing a rising water bill, damp patches on a wall, or a floor that feels cool in one spot. Al Shfa sits at about 21.3823, 39.3352, roughly 24.6 km from the centre of Jeddah, and its built-up area has an approximate radius of 1.2 km. The district centre sits about 117 m above sea level and lies about 15.3 km from the coast, while the nearest wadi channel runs roughly 3 km from the centre. For water tanks, internal coating is priced at SAR 25–65 per m², which is the figure to keep in mind if the inspection shows that a tank lining needs attention.

The visit usually follows a clear sequence. The technician first checks the supply line and meter behaviour with all taps closed, then tests individual zones such as the ground-floor pipework, the roof tank connections and any outdoor irrigation lines. Where a leak is suspected inside a wall or under a slab, the team uses listening and pressure methods to narrow the position before any opening is made, so that finishes are disturbed as little as possible. Each finding is recorded with its location so you can see exactly where the water is going and why.

Before the inspection, prepare a few simple things that save time. Note the dates and approximate figures from your last few water bills, and mark any damp areas, staining or sounds you have noticed. Clear access to the water meter, the tanks, the pump room and any cupboards or shafts where pipes run. If the property has a tank, know roughly its size in square metres of internal surface so the coating estimate can be set against the SAR 25–65 per m² range. Having this ready lets the technician start work straight away.

Prices shown on this page come from our own published price list for the city; the final price is set after inspection.

Signs worth paying attention to

The following signs are worth checking before they grow:

• The meter keeps turning with every tap closed
• A water bill higher than usual with no change in use
• A damp patch that slowly grows on a wall or ceiling
• A hissing or trickling sound in the wall after the taps are off

Where the problem usually comes from

• A corroded joint inside a wall — we check this before anything else.
• A cracked pipe under floor tiles.
• A common cause: a hot line that expands and contracts with use.

Tools and methods, and when we use them

From the first visit to the report

1. Meter test: We stop all use and watch the meter to confirm whether water is actually being lost.
2. Line isolation: We close valves one line at a time to see which line loses pressure.
3. Acoustic listening: We follow the sound of water escaping under pressure and compare its strength between points.
4. Thermal imaging and moisture mapping: We map how far the wet area spreads behind paint and tiles.
5. Documentation: Readings, photos and the likely position go into a written report.

Facts and costs — Al Shfa

Short answers for Al Shfa

Mistakes that cost more

• Repainting the stain while the moisture keeps coming back
• Breaking tiles at random before the line is identified

The written outputs

You receive: a technical report with the readings, the likely leak position and a confidence level, in a technical report with a verification code.