Hidden water leak detection in Al Swary, Jeddah: for companies (annual contract)

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Why hidden water leak detection differs in Al Swary

The centre of Al Swary is at 21.7976, 39.1018, about 29.2 km from the centre of Jeddah, with an approximate radius of 3 km. The approximate area shown on the map is centred here. Al Swary is about 5.2 km from the sea coast (OpenStreetMap).

The centre of Al Swary sits about 2 m above sea level (SRTM open elevation data). Main roads in or near Al Swary: Intercontinental Street, Abdul Majeed Road, King Saud Road.

Hidden water leak detection in Al Swary, Jeddah, starts with the location itself. The centre of Al Swary sits at 21.7976, 39.1018, about 29.2 km from the centre of Jeddah, within an approximate radius of 3 km. Because the district lies only about 2 m above sea level and roughly 5.2 km from the sea coast, a technician should expect low-lying ground and a near-coastal setting. For companies with pipework, pumps or storage tanks here, that combination means moisture can travel through the ground and gather in unexpected places, so the first checks usually focus on low points, ground-level junctions and any area where water has been pooling or where walls and floors feel damp.

Several things cannot be settled from a description alone and are left to the site visit. The technician will need to walk the premises, identify which pipe runs and tanks are actually in use, check for staining, soft ground or unusual readings, and decide how far testing should extend. Any tank that may need recoating should be assessed on site, because the typical internal coating cost is quoted as SAR 25–65 per m², and the final figure depends on the surface area measured and the condition of the existing lining. The visit is also the right time to confirm access, shutdown requirements and any limits on when work can be carried out inside the business.

To help the technician arrive prepared, the company should share its layout drawings, the age and material of the pipework where known, a record of any past leaks or repairs, and details of water meter readings if these are available. It helps to note where bills have risen without explanation and which areas of the building are hardest to inspect. Mention the nearest landmarks or access routes in Al Swary, as well as any staff contact who knows the building well. With this information in hand, the technician can plan the visit efficiently, focus on the most likely leak paths in this low coastal district, and give the business a clearer picture before any repair work begins.

For companies, an annual contract sets the scope, the visit schedule and the reports in writing.

Signs worth paying attention to

The following signs are worth checking before they grow:

• The meter keeps turning with every tap closed
• A water bill higher than usual with no change in use
• A damp patch that slowly grows on a wall or ceiling

The most common causes

• A common cause: a corroded joint inside a wall.
• A cracked pipe under floor tiles.
• A hot line that expands and contracts with use — we check this before anything else.

How we choose the tool in Al Swary

From the first visit to the report

1. Meter test: We stop all use and watch the meter to confirm whether water is actually being lost.
2. Line isolation: We close valves one line at a time to see which line loses pressure.
3. Acoustic listening: We follow the sound of water escaping under pressure and compare its strength between points.
4. Thermal imaging and moisture mapping: We map how far the wet area spreads behind paint and tiles.
5. Documentation: Readings, photos and the likely position go into a written report.

Facts and costs — Al Swary

Short answers for Al Swary

Common mistakes we see

• Repainting the stain while the moisture keeps coming back
• Breaking tiles at random before the line is identified

What you receive

The written output: a technical report with the readings, the likely leak position and a confidence level. The report is numbered and can be checked with its verification code.