Pool leak detection for hotels & serviced apartments in Jeddah

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Jeddah for pool leak detection

Team note on Jeddah: Kashf teams serve this city and its nearby districts with the same documented inspection standard: device-based leak detection without demolition, a written report, and a clear scope before any work begins.. Jeddah is about 2 km from the sea coast (OpenStreetMap).

The centre of Jeddah sits about 15 m above sea level (SRTM open elevation data).

Jeddah sits on the Red Sea coast, and the centre of the city sits about 15 m above sea level, according to SRTM open elevation data. That modest height means that most hotel and serviced apartment pools in the city are built on reasonably level ground, but water is still moved by pumps and pressure, so pipework and joints work hard every day. Our leak detection starts with checking pump pressure and the pipe runs close to the plant room, where a small drop in pressure often points to a problem before any visible wetness appears.

The city is also about 2 km from the sea coast, as recorded in OpenStreetMap. In practice, this means pools here are exposed to salty, humid air and to sea breezes that carry fine salt and dust onto water surfaces, fittings and equipment. Salt-laden air accelerates corrosion on metal fixtures, ladders and pump housings, and it can hide small seepage around fittings. For that reason, our inspections pay close attention to pump housings, return lines and the points where metal meets concrete, because these are the spots where a slow leak tends to start in a coastal setting.

When a leak is confirmed in a concrete tank, the repair often includes restoring the internal surface. Internal tank coating is priced at SAR 25–65 per m², and the exact figure depends on the surface area and condition of the tank. Owners of hotels and serviced apartments benefit from knowing this range early, because it lets them compare the cost of a coating repair with the cost of continued water loss. Our report explains what was found, which areas need coating, and how the figure applies to the specific pool, so decisions can be made calmly rather than in a hurry.

Owners in Jeddah commonly make a few avoidable mistakes. Many wait until the water bill rises or the level drops visibly before calling anyone, which allows a small leak to grow. Others top up the pool repeatedly without finding the cause, or assume that a damp patch near the pool edge must come from the surrounding ground. Some also skip checks on pumps and return lines after a sea breeze season, when salt deposits quietly damage fittings. We help owners avoid these habits by testing early, checking the whole circulation system, and giving a clear picture of what is needed.

For hotels and serviced apartments, rooms are handled in batches to keep units available.

Signs that call for pool leak detection

The following signs are worth checking before they grow:

• The pump draws air
• Damp ground around the pool
• The level drops more than evaporation explains

Where the problem usually comes from

• A common cause: cracks in the shell or tiles.
• The skimmer and return fittings — we check this before anything else.
• A common cause: buried suction and return lines.

How we choose the tool in Jeddah

How the work is done, step by step

1. Documented bucket test: Pool loss is compared with evaporation side by side.
2. Equipment on and off: The test is repeated with the pump running and stopped.
3. Pressure test per line: Each buried line is tested separately.
4. Dye and listening: Fittings and cracks are confirmed with dye and acoustic checks.

Jeddah in facts and sources

Questions from Jeddah

Mistakes that cost more

• Re-tiling the pool before the lines are tested

What you receive

The written output: a result for each line and the likely leak position. The report is numbered and can be checked with its verification code.