Hidden water leak detection for apartments in Al Awaly, Makkah

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Al Awaly for hidden water leak detection

The centre of Al Awaly is at 21.3398, 39.9045, about 7.3 km from the centre of Makkah, with an approximate radius of 5.6 km. The service-area circle on the map below is drawn from this point. Main roads in or near Al Awaly: Prince Sultan Road, Ibrahim Al Jafali Street.

The nearest wadi channel is about 2.4 km from the centre of Al Awaly (OpenStreetMap). The centre of Al Awaly sits about 311 m above sea level (SRTM open elevation data).

Al Awaly sits at 21.3398, 39.9045, about 7.3 km from the centre of Makkah, with an approximate radius of 5.6 km. That distance means many buildings here are set apart from the dense core, so a leak that starts in one block can run unnoticed through shared risers and ground-level pipework before anyone sees damp. Our technicians plan each visit around that spread, checking the building's full water route rather than only the flat where the complaint came from.

The centre of the district is roughly 311 m above sea level, and the nearest wadi channel lies about 2.4 km away. Height and the nearby channel both shape how water moves underground and how it reaches walls and slabs. Pressure changes across the area, and soil that is damp after rain can hide a leak's early signs. For this reason we pair acoustic listening with moisture readings, so that a hidden line is located by what it sounds like and by where the wall or floor is actually wet, not by guesswork.

Owners in Al Awaly often make the same few mistakes, and our service is designed to avoid them. Many wait for a stain to appear on a ceiling before calling anyone, by which time the leak has been running for a long time. Others assume that a drop in the water bill is a sign of good health, when a slow leak can keep the meter moving unnoticed. A common error is repainting a damp wall without finding the source, which only hides the problem until it returns. Tank problems are also overlooked: if a roof or ground tank is failing, internal coating in the range of SAR 25–65 per m² may be needed, and delaying that check lets corrosion spread. We inspect the tanks alongside the pipework so the repair is planned once and done properly.

In an apartment, a problem may start in your unit or in a shared line; we separate the two before any work.

When do you need hidden water leak detection?

These are the signs most often linked to hidden water leak detection:

• A damp patch that slowly grows on a wall or ceiling
• A hissing or trickling sound in the wall after the taps are off
• The meter keeps turning with every tap closed

Causes we see in the field

• A hot line that expands and contracts with use — we check this before anything else.
• A common cause: a corroded joint inside a wall.
• A cracked pipe under floor tiles — we check this before anything else.

Tools and methods, and when we use them

From the first visit to the report

1. Meter test: We stop all use and watch the meter to confirm whether water is actually being lost.
2. Line isolation: We close valves one line at a time to see which line loses pressure.
3. Acoustic listening: We follow the sound of water escaping under pressure and compare its strength between points.
4. Thermal imaging and moisture mapping: We map how far the wet area spreads behind paint and tiles.
5. Documentation: Readings, photos and the likely position go into a written report.

Facts and costs — Al Awaly

Questions from Al Awaly

Common mistakes we see

• Repainting the stain while the moisture keeps coming back
• Breaking tiles at random before the line is identified

What you receive

The written output: a technical report with the readings, the likely leak position and a confidence level. The report is numbered and can be checked with its verification code.