Hidden water leak detection in Al Qrara Al Jdyd, Makkah: emergency

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Hidden water leak detection in Al Qrara Al Jdyd: the local context

The centre of Al Qrara Al Jdyd is at 21.2825, 39.7825, about 14.2 km from the centre of Makkah, with an approximate radius of 1.2 km. The approximate area shown on the map is centred here. The centre of Al Qrara Al Jdyd sits about 205 m above sea level (SRTM open elevation data).

The nearest wadi channel is about 1 km from the centre of Al Qrara Al Jdyd (OpenStreetMap).

Al Qrara Al Jdyd sits in Makkah at approximately 21.2825, 39.7825, about 14.2 km from the centre of Makkah, with an approximate radius of 1.2 km. That means the district lies well outside the dense old core, so a call-out here often means a longer drive for a technician and a need to confirm the exact address and access route before arriving. Pinning the coordinates in your request helps us dispatch the right crew without delay during an emergency.

The centre of the district is roughly 205 m above sea level, according to SRTM open elevation data. In practical terms, this elevation affects how water pressure behaves in the building network. Changes in height across a property can shift pressure between upper and lower floors, so a leak may appear first on a lower level or in a storage tank rather than where the water is seen. Our technicians take this into account when they trace pipe runs and check pressure readings, rather than assuming the visible damage marks the source.

The nearest wadi channel lies about 1 km from the centre, based on OpenStreetMap data. Ground near a seasonal channel can hold moisture differently from dry sites, and this can make a buried or slab leak harder to separate from natural dampness. When assessing a property close to such a channel, we check the soil around the affected line and note whether water movement comes from the supply side or from ground seepage. Owners should also tell us about any recent rainfall or flooding, as this changes what the readings mean.

Common mistakes owners avoid include waiting for a stain to grow before calling, cutting into walls before a leak has been located, and assuming a tank is sound without checking it. Tank internal coating is priced at SAR 25–65 per m², so an owner who replaces a damaged lining without first locating the leak may pay for work that does not solve the problem. We advise confirming the source first, then deciding on repair or coating.

If water is flowing, close the main valve first, then call or message with photos.

Signs that call for hidden water leak detection

The following signs are worth checking before they grow:

• A water bill higher than usual with no change in use
• The meter keeps turning with every tap closed
• A hissing or trickling sound in the wall after the taps are off

Where the problem usually comes from

• A cracked pipe under floor tiles — we check this before anything else.
• A corroded joint inside a wall — we check this before anything else.
• A hot line that expands and contracts with use.

How we choose the tool in Al Qrara Al Jdyd

From the first visit to the report

1. Meter test: We stop all use and watch the meter to confirm whether water is actually being lost.
2. Line isolation: We close valves one line at a time to see which line loses pressure.
3. Acoustic listening: We follow the sound of water escaping under pressure and compare its strength between points.
4. Thermal imaging and moisture mapping: We map how far the wet area spreads behind paint and tiles.
5. Documentation: Readings, photos and the likely position go into a written report.

Quick comparison: facts and costs in Al Qrara Al Jdyd

Questions from Al Qrara Al Jdyd

What we advise against

• Breaking tiles at random before the line is identified
• Repainting the stain while the moisture keeps coming back

What you get after the work

The written output: a technical report with the readings, the likely leak position and a confidence level. The report is numbered and can be checked with its verification code.