High water bill for residential buildings in Al Aard, Riyadh

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Al Aard for high water bill

The centre of Al Aard is at 24.8935, 46.6060, about 21.2 km from the centre of Riyadh, with an approximate radius of 8 km. The service-area circle on the map below is drawn from this point. The nearest wadi channel is about 1 km from the centre of Al Aard (OpenStreetMap).

The centre of Al Aard sits about 671 m above sea level (SRTM open elevation data). Main roads in or near Al Aard: King Fahd Road, King Abdulaziz Road, Abu Bakr Al Siddiq Road.

Imagine the owner of a multi-storey residential building in Al Aard who opens a water bill and finds it far higher than last month. The flats are occupied as usual, nobody reports a new appliance, and the building manager is left wondering where the extra water went. Owners in this situation often assume the meter is at fault, when the cause is frequently inside the building, in the rooftop tank, the pipework or the pump settings.

Al Aard sits at roughly 24.8935, 46.6060, about 21.2 km from the centre of Riyadh, with an approximate radius of 8 km, so it lies well outside the old core and many buildings here were built in phases. The centre of the area is about 671 m above sea level, which means water is usually lifted to rooftop tanks by pump rather than flowing by gravity, and a pump that runs longer than it should will quietly inflate consumption. The nearest wadi channel is about 1 km from the centre, a reminder that the ground is open and dusty and that tank lids and vents need to be kept sealed against debris, which can contaminate stored water and prompt unnecessary flushing. For an owner, these local facts point to the rooftop and pump as the first places to look rather than the street supply.

Start by checking the tank: switch off the pump, note the water level, and watch for an hour to see whether the level drops, which would signal a leak in the tank or outlet pipes. Next, inspect the tank's internal coating; where the lining is cracked or flaking, the cost of restoring it is quoted per square metre, typically SAR 25–70 per m², so measure the surface and ask for a written figure before agreeing any work. Then confirm the float valve shuts off fully, since a valve that keeps refilling causes overflow losses that go unnoticed. Check the pump's run timer or pressure switch so it stops once the tank is full. Finally, walk the building for dripping taps, running toilet cisterns and any leaking joints, fix what you find, and compare the next bill against the previous period to confirm the change.

For a residential building, shared risers, tanks and pumps are checked as one system.

When do you need high water bill?

The following signs are worth checking before they grow:

• The meter moves at night
• A sudden jump in the bill without a clear reason
• The tank fills more often than before

Causes we see in the field

• A silent leak in the network.
• A float valve that does not close — we check this before anything else.
• A common cause: a leaking toilet cistern.

How we choose the tool in Al Aard

How the work is done, step by step

1. Two meter readings: Readings are taken with all use stopped, some time apart.
2. Cisterns and float valve: The usual silent causes are checked first.
3. Instrument survey: If the loss continues, the network is surveyed with instruments.
4. Report: You receive the readings in writing.

Quick comparison: facts and costs in Al Aard

Common questions about high water bill in Al Aard

What we advise against

• Waiting for the next bill instead of testing the meter

The written outputs

The written output: a report with the readings to support your follow-up on the bill. The report is numbered and can be checked with its verification code.