High water bill for rest houses & farms in Al Alya, Riyadh

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Before we start: what we know about Al Alya

The centre of Al Alya is at 24.6931, 46.6845, about 2.5 km from the centre of Riyadh, with an approximate radius of 3 km. The approximate area shown on the map is centred here. Al Alya is largely commercial, with shops and offices.

The centre of Al Alya sits about 622 m above sea level (SRTM open elevation data). Main roads in or near Al Alya: King Fahd Road, Makkah Road, Al Olaya Street.

Al Alya sits at 24.6931, 46.6845, roughly 2.5 km from the centre of Riyadh, and its area has an approximate radius of 3 km. The district is largely commercial, with shops and offices rather than the open farmland and detached rest houses found further out. For a high water bill, this mix matters. Commercial buildings often run water-heavy fixtures, cleaning routines and staff facilities, so a rest house or small farm sitting among them may be drawing on the same network pressure and usage patterns. Our technicians begin by asking owners what has changed in their daily routine, not only what the meter shows.

The centre of Al Alya sits about 622 m above sea level, according to SRTM open elevation data. Elevation shapes how water moves through a property. At this height, tanks and pumps can work harder to maintain pressure, particularly on upper floors or in higher garden areas, and a pump that cycles more often than it should can quietly raise consumption. Because of this, our inspections look at float valves, pump run times and pressure settings alongside visible leaks. The internal coating of a storage tank is also worth checking, since the tank surface affects how cleanly it holds water and how often it needs attention. Tank internal coating is priced at SAR 25–65 per m², and the final figure depends on the tank's size and condition, which we confirm on site before any work begins.

Owners in this area often make the same avoidable errors. The most common is ignoring a slow, constant drip at a float valve, because it seems too small to matter, when over a month it adds up on the bill. Another is assuming a high bill must come from a burst pipe and overlooking a running pump or an overflowing tank. Some owners also wait until the bill has already spiked before calling anyone, which leaves less information to work from. Keeping a simple record of monthly readings and noting any change in use makes a diagnosis far faster. Checking these points early usually shows where the water is going.

Rest houses and farms often have long buried lines, tanks and irrigation that need separate tests.

When do you need high water bill?

If you notice one of these signs in Al Alya, it is a good moment to talk to the team:

• A sudden jump in the bill without a clear reason
• The meter moves at night
• The tank fills more often than before

Where the problem usually comes from

• A float valve that does not close — we check this before anything else.
• A common cause: a silent leak in the network.
• A leaking toilet cistern.

Tools we use in Al Alya

How the work is done, step by step

1. Two meter readings: Readings are taken with all use stopped, some time apart.
2. Cisterns and float valve: The usual silent causes are checked first.
3. Instrument survey: If the loss continues, the network is surveyed with instruments.
4. Report: You receive the readings in writing.

Al Alya in facts and sources

Questions from Al Alya

Mistakes that cost more

• Waiting for the next bill instead of testing the meter

What you receive

The written output: a report with the readings to support your follow-up on the bill. The report is numbered and can be checked with its verification code.