High water bill for villas in Al Aqyq, Riyadh

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

What is specific about Al Aqyq for high water bill

The centre of Al Aqyq is at 24.7740, 46.6309, about 8.1 km from the centre of Riyadh, with an approximate radius of 2.8 km. The approximate area shown on the map is centred here. Main roads in or near Al Aqyq: King Fahd Road, Northern Ring Road, Prince Mohammed bin Salman bin Abdulaziz Road.

The nearest wadi channel is about 0.7 km from the centre of Al Aqyq (OpenStreetMap). The centre of Al Aqyq sits about 647 m above sea level (SRTM open elevation data).

Consider a villa owner in Al Aqyq, a neighbourhood about 8.1 km from the centre of Riyadh. A household like this often sees the water bill climb over a few months without any obvious change in daily habits. Garden irrigation, a pool top-up or a rooftop tank that refills more often than expected can all push usage higher, and the bill arrives before the cause is clear. For many owners the first question is whether the meter is recording correctly or whether water is quietly escaping somewhere on the property.

The local setting matters here. The centre of Al Aqyq sits at 24.7740, 46.6309 and about 647 m above sea level, and the nearest wadi channel runs about 0.7 km from the centre. Storage tanks on higher roofs or ground-level tanks can lose water through cracks, worn fittings or an aged internal lining, and that loss shows up as extra consumption rather than as a visible leak. Interior tank coating is typically priced at SAR 25–65 per m², so an owner weighing a repair should compare the cost of that work against the water being lost each month.

A sensible order of action starts with a simple check. Switch off every tap and appliance, note the meter reading, and check it again after two hours; a moving reading points to a leak on the property. Next, inspect the storage tank, the overflow pipe and the outdoor taps and irrigation lines for drips or wet patches. Then review the usual drivers of high use, such as sprinklers running at midday or a pool being refilled too often. If the leak is not found, ask a qualified plumber to test the tank and pipework, and request a written quote that states the coating area in square metres so the price can be checked against the SAR 25–65 per m² range.

In a villa, tanks, the roof and the yard lines are usually yours to look after, so it helps to know where the main valve and tank hatches are.

Signs worth paying attention to

These are the signs most often linked to high water bill:

• The tank fills more often than before
• The meter moves at night
• A sudden jump in the bill without a clear reason

Causes we see in the field

• A leaking toilet cistern — we check this before anything else.
• A silent leak in the network — we check this before anything else.
• A common cause: a float valve that does not close.

Tools and methods, and when we use them

The steps in order

1. Two meter readings: Readings are taken with all use stopped, some time apart.
2. Cisterns and float valve: The usual silent causes are checked first.
3. Instrument survey: If the loss continues, the network is surveyed with instruments.
4. Report: You receive the readings in writing.

Facts and costs — Al Aqyq

Common questions about high water bill in Al Aqyq

Common mistakes we see

• Waiting for the next bill instead of testing the meter

What you receive

You receive: a report with the readings to support your follow-up on the bill, in a technical report with a verification code.