Building restoration in Al Hzm, Riyadh: cost & published offers

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Why building restoration differs in Al Hzm

The centre of Al Hzm is at 24.5473, 46.6536, about 18.6 km from the centre of Riyadh, with an approximate radius of 1.2 km. The approximate area shown on the map is centred here. Main roads in or near Al Hzm: Dirab Road, Najm al-Din al-Ayyubi Street, Al Sahra Road.

The centre of Al Hzm sits about 676 m above sea level (SRTM open elevation data). The nearest wadi channel is about 0.8 km from the centre of Al Hzm (OpenStreetMap).

Is restoration work in Al Hzm, Riyadh, priced in a way I can plan for before an inspector arrives? Published figures for this area are straightforward. A maintenance visit typically falls between SAR 160 and SAR 420 per visit, while restoration is quoted per square metre, usually between SAR 55 and SAR 160 per m². The spread in each range reflects the scope of the work, so the final figure depends on what the building needs once it has been assessed on site. Al Hzm is centred at 24.5473, 46.6536, roughly 18.6 km from the centre of Riyadh, and it covers an approximate radius of 1.2 km, so most properties here are a short drive from the city's main districts but sit in a distinct local area.

The inspection itself follows a clear sequence. The technician starts with a walk around the outside of the building to note cracks, staining, and the condition of rendering and joints. Because the centre of Al Hzm sits about 676 m above sea level and the nearest wadi channel runs about 0.8 km from the centre, the inspector also checks how water moves across and around the plot, looking at drainage routes, ground levels near the foundations, and any signs of past water damage on lower walls. Inside, the inspector examines walls, ceilings, and floors for moisture, then notes the roof condition and any areas that have been patched before. The findings are recorded room by room so that the eventual quote matches the real condition of the property rather than a general estimate.

Preparing a few things beforehand makes the visit more useful and can keep the quote accurate. Gather any earlier maintenance records, previous repair invoices, and details of when the building was constructed or last renovated. Clear access to the roof, the external walls, and any utility spaces, and note the areas where you have already seen leaks, cracks, or damp patches. It also helps to write down the floor plan or the approximate square metres of each section, since restoration pricing is calculated per m². Having these details ready lets the inspector focus on the problems that matter and gives you a clearer picture of the cost range before any work is agreed.

Prices shown on this page come from our own published price list for the city; the final price is set after inspection.

Signs worth paying attention to

These are the signs most often linked to building restoration:

• Damage left after a leak
• Cracks in the plaster
• Peeling paint

The most common causes

• A leak that was never treated.
• The age of the building.
• Earlier damp.

Tools we use in Al Hzm

From the first visit to the report

1. Survey: The cause of the damage is recorded.
2. Treating the cause: The water source is stopped first.
3. Restoration: Plaster, tiles and paint.
4. Handover: Before-and-after photos.

Facts and costs — Al Hzm

Short answers for Al Hzm

Common mistakes we see

• Restoring before the damp source is stopped

What you receive

You receive: before-and-after photos and the work done, in a technical report with a verification code.