High water bill for apartments in Atyqa, Riyadh

Prepared by the technical team · editorial review · last updated 13 November 2026 · Sources

Before we start: what we know about Atyqa

The centre of Atyqa is at 24.5967, 46.7084, about 13.4 km from the centre of Riyadh, with an approximate radius of 1.2 km. The approximate area shown on the map is centred here. The nearest wadi channel is about 0.4 km from the centre of Atyqa (OpenStreetMap).

The centre of Atyqa sits about 588 m above sea level (SRTM open elevation data). Main roads in or near Atyqa: South Ring Road, King Fahd Road, King Fahd Branch Road.

Imagine an owner who lets a few apartments in a building in the Atyqa neighbourhood of Riyadh. One month the water bill arrives far higher than usual, and tenants start asking whether there is a leak. The owner wants to know if the cause is the building itself, the supply, or the storage tank on the roof, and wants a clear way to check without guessing.

The local facts matter here. Atyqa is centred at 24.5967, 46.7084, about 13.4 km from the centre of Riyadh, with an approximate radius of 1.2 km, so it sits on the outer edge of the city rather than in its dense core. Its centre is about 588 m above sea level, and the nearest wadi channel is roughly 0.4 km away. For an owner, this means the building is not in a low-lying hollow, and the nearby wadi is a reminder that the area is shaped by seasonal flow and dust. Such conditions can affect the condition of rooftop tanks and their surfaces over time, so the tank deserves attention alongside the pipes and fittings.

Start by reading the meter and comparing the figures with previous bills, noting the date of each reading so the increase can be measured. Next, check every apartment and common tap, toilet cistern and outdoor hose for dripping or running water, and listen for a tank that refills when no one is using water. Inspect the rooftop tank for cracks, flaking or staining, and look at the inside surface if it can be safely opened, since a damaged internal coating can allow leakage and contamination. If the coating needs replacing, the cost is quoted at SAR 25–65 per m², so measure the tank's internal area before asking for estimates. Finally, if the leak is still unexplained after these checks, arrange a plumber to test the pipework, and keep written records so tenants and the owner can see what was found and what was repaired.

In an apartment, a problem may start in your unit or in a shared line; we separate the two before any work.

Signs worth paying attention to

If you notice one of these signs in Atyqa, it is a good moment to talk to the team:

• The meter moves at night
• A sudden jump in the bill without a clear reason
• The tank fills more often than before

The most common causes

• A common cause: a silent leak in the network.
• A float valve that does not close — we check this before anything else.
• A leaking toilet cistern.

Tools and methods, and when we use them

The steps in order

1. Two meter readings: Readings are taken with all use stopped, some time apart.
2. Cisterns and float valve: The usual silent causes are checked first.
3. Instrument survey: If the loss continues, the network is surveyed with instruments.
4. Report: You receive the readings in writing.

Atyqa in facts and sources

Common questions about high water bill in Atyqa

What we advise against

• Waiting for the next bill instead of testing the meter

What you receive

You receive: a report with the readings to support your follow-up on the bill, in a technical report with a verification code.